1975 Contessa 35

$37,000
Payment Calculator icon $---/month

Estimated Monthly Payments

$---/month
Calculate your Payment Get a Quote
Estimated payments are for informational purposes only and do not account for tax, title and fees or represent a guarantee of credit from the seller. Such estimates are not an offer or commitment to lend.

Warwick, RI

Close Map

Get Directions

View Dealer Inventory
Class Sails
Category Racers and Cruisers, Racers
Year 1975
Make Contessa
Length 35'
Propulsion Type Other
Hull Material Fiberglass
Fuel Type
Location Warwick, RI
Full Description

SPECIFICATIONS:

Builder: Jeremy Rogers Yachts Lymington, England
Designer: Doug Peterson
Keel: Fin      Rudder: Spade 

Dimensions
LOA: 35 ft 6 in
Beam: 11 ft 6 in
Maximum Draft: 6 ft 10 in modified with 6 lead keel shoe Engine

Engine:
Yanmar 3JH3E  Diesel Inboard 40 HP
Installed new in 2002.  W/ approx. 700  hours @ 10/2018

Tanks:
Custom Fresh Water: 56 gal in two tanks
Custom Fuel Tanks:46 gal in two tanks 

INTERIOR

ANDARA, has undergone an extensive structural and cosmetic refit under her current owner of 18 years.  The interior was stripped down to the stringers and rebuilt with new bulkheads, furniture, water and electrical systems and electronics.  A large portion of the cabin house and deck was re-cored at the same time.  In short, this vessel is one of the most modern and structurally sound Contessa 35s to be found today.  In addition, the hull was stripped below the waterline and barrier coated in 2010 and the topsides Awlgripped in 2014.  

ACCOMODATIONS

Sleeps a total of 7.  One in Quarter Berth, 4 in the Main Salon and 2 in forecastle pipe-berths. One  Lavac head w/ raw water flush.  Interior furniture is either solid teak, teak laminates or veneered teak over marine ply with varnish finish. Teak and holly cabin sole new in 2003. Removable vinyl covered overhead panels. Blue upholstery in the saloon.

FORECASTLE

Open forecastle for sail and gear stowage with 2 pipe berths.  Anchor locker at bow.

Located aft of the forecastle on the port side is the head.  Single fiberglass unit with Lavac manual head. Pressure hot and cold water with Telephone type shower. Mirror and gear/toiletries shelves.

Across from forward head are two hanging lockers with drainage for wet gear, two large equipment drawers and an equipment locker.

MAIN SALOON

Located aft of the forward cabin and head. "L" shaped settee to port with pilot berth outboard. Straight settee to starboard with pilot berth outboard. Fixed table on the centerline with leaves port and starboard.

NAVIGATION STATION

Located aft of the saloon on the starboard side. Forward facing.

GALLEY

Located opposite the navigation station and aft of the main saloon. "U" shaped. White corian counter tops. One stainless steel sink near the centerline. Single Ice Chest.  Origo 2 burner non-pressurized alcohol stove with oven.  Drawers and lockers.

QUARTER BERTH

Located aft of the navigation station on the starboard side.

HULL

  • Solid fiberglass hull using polyester resin
  • Bottom treated with epoxy primer (2010) and painted
  • Structural bulkheads are marine grade plywood.  All high-gloss varnish.
  • Awlgripped in 2014 (color: Beaujolais) and clear coated
  • Gold Awlgrip Cove Stripe and Oyster White Boot Stripes
  • Fin keel with 6 additional lead shoe at base.  Keel bolts re-tourqued in 2017
  • Spade rudder new in 1998 with aluminum stock, and aluminum rudder cap (replaced in 2005)
  • Tiller steering with Raymarine Tiller Pilot
  • Bronze through hulls
  • Grounded throughout

DECK

  • Deck cored with end-grain balsa wood and closed cell foam (2003 repairs)
  • Inward flange hull-to-deck joint through-bolted.
  • New teak toe rail in 2003.
  • Single cockpit
  • Stainless steel stem head fitting with single anchor housing
  • Stainless steel bow rail
  • Stainless steel stern rail<
Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Dimensions
Nominal Length
35
Length Overall
35.5
Beam
11.5
Accommodations
Heads
1
Engine Type Other
1975 Contessa 35

 An absolute beauty with new awlgrip (in 2014), new barrier coated bottom, newer Yanmar (2002) with approximately 700 hours, refurbished interior, Espar diesel heat, solid hand laid fiberglass hull, newer electronics Fairclough winter cover and very nice sails!    Refurbished and customized by her marine professional owner and is available due to recent change in the owners plans.  A fast fin-keeled cruiser/ racer with tiller steering, sturdy construction and timeless lines. She has a proven race record and won't disappoint. You will not find another Contessa 35 as well maintained as this one!

ANDARA, has undergone an extensive structural and cosmetic refit under her current owner of 18 years.  The interior was stripped down to the stringers and rebuilt with new bulkheads, furniture, water and electrical systems and electronics.  A large portion of the cabin house and deck was re-cored at the same time.  In short, this vessel is one of the most modern and structurally sound Contessa 35s to be found today.  In addition, the hull was stripped below the waterline and barrier coated in 2010 and the topsides Awlgripped in 2014.  This is a beautiful boat to behold and one that can take her new owner around the world or around the buoys with equal ease.

The Contessa 35 was ahead of her time when designed by Doug Peterson and she is still competitive today.  She lacks nothing and is a must-see beauty.  Please view the photos.  She is available with the option of a slip at an upscale Rhode Island marina.....there is no sales tax on boats in RI.  Easily shipped worldwide from 2 local shipping ports.

 

Request Information Call Now View Dealer Inventory